- 4" x 150' Floor & Pavement Marking Tape - STANDARD GRADE

Our 4" x 150' STANDARD GRADE pavement marking tape rolls are designed to stripe asphalt & fully cured concrete surfaces, parking garages, warehouse floors, factory floors, roads and any other area where high visibilty delineation is needed. Self adhesive, conformable, aluminum based product.  Our Standard Grade tape is mildly reflective and more affordable than our premium grade.

• Available in yellow and white. 
• Self adhesive, conformable, aluminum based product. 
• Semi permanent or temporary applications.
• Can be removed. (Note - tape is fine for straight lines but is not flexible enough to create curved lines.)
• Simple installation procedure. Must be pressed in VERY well to surface.
• Our affordable STANDARD GRADE tape is mildly reflective.
• Consists of an alumimum film coated with adhesive on the bottom and coated with paint and reflective glass beads on the top.
• Holds up to traffic driving straight over it.  However, twisting tires can cause it to release. (priming surface with contact cement will enhance adhesion)

NOTE - IT IS VERY IMPORTANT THAT THIS TAPE BE PRESSED ONTO THE SURFACE WITH ENOUGH PRESSURE TO CONFORM IT 100% TO THE SURFACE. OTHERWISE THE TAPE WILL COME BACK UP. ALL EDGES NEED TO BE COMPLETELY ADHERED TO THE SURFACE.  SINCE WE HAVE NO CONTROL OVER THE SURFACE THE TAPE IS APPLIED TO AND THE APPLICATION METHOD THERE ARE NO REFUNDS OR WARRANTY ON THIS PRODUCT.

Our tape is simple to install with no special equipment or contractor required. Click here to see installation pictures and instructions. If the tape gets damaged it just takes a few minutes to replace the damaged piece. It is as thick as normal parking lot paint and has a durable, reflective surface. The tape's aggressive adhesive and conformable foil backing insure that when properly applied your reflective white or yellow lines will remain in place. It can be removed if necessary. Longevity depends on traffic flow and proper installation.

The tape performs best on smooth surfaces where all of the tape can make contact with the surface. The tape MUST be pressed onto the surface VERY WELL for it to perform properly. A rubber tired dolly with heavy weight on it is often sufficient. An automobile tire is best. A golf cart can also be used. Multiple passes are often necessary.

Parking lots or warehouses with moderate to light traffic often get years of service out of the tape. The tape can handle traffic rolling straight over it, however, the life of the tape will be greatly reduced in areas where tires twist the tape excessively. For large projects we suggest you install a roll of the tape first to determine if it will meet your requirements. Sand, dirt, oil or sealcoat with prevent this product from adhering properly.

To install our striping tape simply apply it to a clean, dry surface and press it on. The temperature should be in excess of 50 degrees. Dry, clean, sun warmed asphalt or cement is ideal. Proper adhesion can be achieved by going over the tape with a bouncy rubber tire by using your vehicle tire. A lot of pressure is necessary. This conforms the tape to the surface and forms a seal that keeps water from getting under the tape.  If the surface is so rough that a proper seal cannot be acheived then water will get underneath the tape, cars will roll over it, and this action will force the tape off the surface.  When using a vehicle to press the tape in be careful not to turn the steering wheel while on the fresh tape. Also, avoid applying the tape to damp asphalt or cement. It is best to apply when it has not rained in 48 hours. After application the tape is ready for traffic. Full curing occurs after about 48 hours and it is best if it does not rain during this time as well. For heavy traffic areas or where tires will be twisting on the striping try our "preformed thermoplastic striping" by clicking on the link to the left.

SINCE WE HAVE NO CONTROL OVER THE SURFACE THE TAPE IS APPLIED TO AND THE APPLICATION METHOD THERE ARE NO REFUNDS OR WARRANTY ON THIS PRODUCT.

We carry the foil backed pavement tape in both WHITE and YELLOW.  The STANDARD GRADE pavement tape on this page is mildly reflective and more affordable than our premium grade.  Click above to make your choice.

CLICK HERE FOR MORE PHOTOS OF THIS PRODUCT
CLICK HERE FOR INSTALLATION INSTRUCTIONS FOR THIS PRODUCT
Installation instructions for difficult surfaces