- 12" x 30' Preformed Thermoplastic Roll
Our 12" preformed thermoplastic pavement marking tape ROLLS are designed to stripe stop bars, crosswalks and any other area where heavy duty, high visibility delineation is needed. It is great for quickly creating crosswalks, stop pads, hazard areas, arrows and other markings. Bonds to asphalt or cement surfaces.
For crosswalks you use two single 12" lines spaced apart and for stop bars you use two side by side to form a 24" bar. For arrows you use an exacto knife to score the material and create the parts of the arrow. This product will last 5 times longer than paint, is reflective and best of all, you can put it down yourself. No contractor required.
Our tape is simple to install using a broom and a propane torch. No contractor required. It is 90 mils thick and has a durable, reflective, non skid surface. Since this is a melt on type product the tape will conform and bond to moderately rough surfaces or smooth surfaces and is incredibly tough. When properly installed you will get years of service out of this material. It can handle any type of traffic.
To apply simply broom or blow off the dry, oil free area to be striped, heat the area to 300 degrees with a propane torch, lay out the stripe and then slowly heat the surface of the stripe until a permanent bond is created. When heating, keep the flame moving and be especially careful not to overheat cement. A handheld infrared thermometer is recommended. Once the material has cooled the area is ready for traffic. Please refer to the link below for complete instructions. It is important for this product to be installed properly. Safety goggles are recommended.
On this page we sell this tape by the roll in WHITE.
Available by the roll - $179.99 plus shipping
Make your selection below.
CLICK HERE FOR INSTALLATION PHOTOS
Our tape is simple to install using a broom and a propane torch. No contractor required. It is 90 mils thick and has a durable, reflective, non skid surface. Since this is a melt on type product the tape will conform and bond to moderately rough surfaces or smooth surfaces and is incredibly tough. When properly installed you will get years of service out of this material. It can handle any type of traffic.
To apply simply broom or blow off the dry, oil free area to be striped, heat the area to 300 degrees with a propane torch, lay out the stripe and then slowly heat the surface of the stripe until a permanent bond is created. When heating, keep the flame moving and be especially careful not to overheat cement. A handheld infrared thermometer is recommended. Once the material has cooled the area is ready for traffic. Please refer to the link below for complete instructions. It is important for this product to be installed properly. Safety goggles are recommended.
On this page we sell this tape by the roll in WHITE.
Available by the roll - $179.99 plus shipping
Make your selection below.
CLICK HERE FOR INSTALLATION PHOTOS
Click To Enlarge
- Item #: 12_thermo_roll
